How do I calibrate the LED panel after changing the modules?
For most panels, the calibration data is stored on the LED modules. To read the correct calibration data into the receiver card, power-cycle the panel once. The correct calibration data will be loaded into the receiver card when the LED panel is powered on.
However, there is some variation between panels and systems. A general recommendation is as follows: If the calibration does not recover in 15sec, power cycle the LED panel. If it still does not recover, check the instructions specific for your control system and LED panel.
Events
-
14 Apr.
Virtual Productions Gathering at BUas, Breda, Netherlands
ROE Visual is proud to be Platinum Sponsor of the Virtual Production Gathering 2026, taking place from April 14-16 in Breda, The Netherlands. Under the banner "Leaders of the Craft" this will be 3 day...
News
-
02 Mar.
Fournell Invests in Topaz TP1.9
ROE Visual is proud to announce that Fournell Showtechnik has invested in ROE Visual’s Topaz 1.9 LED panels, further strengthening its premium rental inventory. In addition to the initial purchase, Fo...